Demco DA10 Specifications download pdf (Page 8)

Page 8

WELDING

Tack Actuator down on the

four corners then weld in

a criss cross pattern us-

ing 2” to 2-1/2” welds with

2” spaces between welds

(when welding down to a

ﬂat area of the tongue)

Do not weld in the

circled area

Do not weld in the

circled area

Keep braces and welds

back to allow access to

shock pin holes

Keep braces

and welds back

to allow access

to shock pin

hole

Use gussets to support the

back of the actuator if welding

in position shown

Keep gussets on

rear of actuator

to lower half to

avo i d c i rc le d

area

Weld as shown

NOTE: disassembly of the actuator before welding is recommended

The weight rating of the coupler is dependent on the correct bolts being used. You must use the

exact size, grade and number of bolts speciﬁed in the manual. Mounting hardware can be obtained

from Demco, trailer parts distributors or fastener supplier.

WARNING: TO AVOID PERSONAL INJURY OR PROPERTY

DAMAGE, OBSERVE THE FOLLOWING INSTRUCTIONS:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Demco DA10 Specifications Page 8